Tel: 01633 - 256067
| Part Number | Model | Description | Picture |
|---|---|---|---|
| SWP49 | All models | Front stabiliser link bar L&R |
|
| SWP969 | All models | Ball joint, front |
![]() |
| SWP410B/N | All models | Wishbone nut & bolt Fits through SWP431 |
![]() |
| SWP411B/N | All models | Wishbone nut & bolt Fits through SWP430 |
![]() |
| SWP403/4 | All models | Wishbone, pinch bolt & nut |
![]() |
| SWP430 | All models | Front wishbone, front bush |
![]() |
| SWP431 | All models | Front wishbone, rear bush |
![]() |
| SWP5941 | All models | Top strut mounting, rear |
![]() |
| SWP5942 | All models | Top strut mounting, front |
![]() |
| SWP5942B | All models | Top strut bearing, front |
![]() |
| SWP5942K | All models | Top strut bearing & mounting kit front |
![]() |
| SWP56 | All models | Front anti roll bar bush 16.5mm |
![]() |
| SWP5939 | 1.25, 1.3, 1.4 | Front anti roll bar bush 15mm |
![]() |
| SWP112 | All models | Brake calliper guide kit. [Eliminates brake shudder] |
![]() |
| DC48 | 1.25 1-8-95 – 1-12-00 1.4 ZETEC 11-1-96 – 1-12-00 1.6 ZETEZ 11-1-96 – 1-12-00 As: 1122713 |
Oil filler cap |
![]() |
| SWP6746 | 1.25 1-12-00→ 1.4 ZETEC 1-12-00→ With plastic cover 1.6 ZETEZ 1-12-00→ With plastic cover As: 1135010 |
Oil filler cap |
![]() |
| SWP138 | 1.3 EFi only | Oil filler cap/breather |
![]() |
| SWP6009 | All models | Rear axle bush |
![]() |
| SWP58 | All models | Side repeater lens, AMBER from |
![]() |
| SWP69 | All models | Bulb holder to suit side indicator lens |
![]() |
| FWP3 | All models | Washer pump, twin outlet |
![]() |
| SWP6689 | All Models | Wiring harness to suit FWP3 washer pump |
![]() |
| HN21 | All models | Rear hub nut L&R |
![]() |
| HN21KIT | All models | Rear hub nut & grease cap kit L&R |
![]() |
| SWP2223 | All models | Rear hub, grease cap |
![]() |
| SWP2124K | 1.6i, 1.8i, ZETEC ENGINE | Sump plug & rubber seal |
![]() |
| SWP2124W | 1.6i, 1.8i, ZETEC ENGINE | Rubber seal for sump plug |
![]() |
| SWP5893 | All models | Rear axle, rear bush For vehicles with a trussed chassis |
![]() |
| SWP2183 | 1.8 Diesel | Oil filler cap |
![]() |
| FFF FL2 | All models | Front fog lamp LH |
![]() |
| FFF FL3 | All models | Front fog lamp RH |
![]() |
| SWP12614C | 1.25i, 1.3i, 1.4i, 1.6i | Electronic coil for Distributorless ignition |
![]() |
| SWP12714C | 1.25i, 1.3i, 1.4i, 1.6i | Electronic coil |
![]() |
| SWP1116 | ZETEC only | Thermostat housing |
![]() |
| SWP6030 | All models | Heater control valve See item below for wiring harness SWP6692 |
![]() |
| SWP6692 | All models | Heater control valve electrical harness socket
To fit SWP6030 ITEM ABOVE |
![]() |
| SWP5958 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump, In-line An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
|
| SWP6345 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump. One straight end, one 90º end An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
|
| SWP6346 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump. Both ends at 90º angle. An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
![]() |
| SWP363 | All models, with power steering | Steering coupling |
![]() |
| SWP362 | All models, with power steering | Steering coupling [End only] |
![]() |
| SWP6726 | 1.25i, 1.3i, 1.4i, 1.6i, 1.8d | Driveshaft seal | ![]() |
| SWP6748 | Various models: Please check against photograph |
Under body heat shield [exhaust to floor] & noise insulations on bulk head [30mm OD] |
![]() |