Tel: 01633 - 256067
| Part Number | Model | Description | Picture |
|---|---|---|---|
| SWP401/2 | All models | Wishbone, shank bolt & nut |
![]() |
| SWP403/4 | All models | Wishbone, pinch bolt & nut |
![]() |
| SWP102L | All models | Wishbone bush, large |
![]() |
| SWP103s | All models | Wishbone bush, small |
![]() |
| SWP49 | All models | Front stabiliser link bar L&R |
|
| SWP56 | All models | Anti roll bar bush, front 16.5mm |
![]() |
| SWP145 | All models | Rear axle bush |
![]() |
| FSC | All models, without power steering | Steering coupling |
![]() |
| CPR2 | All models | Clutch ratchet & pawl kit |
![]() |
| SWP700 | All models without air bag | Bonnet pull handle |
![]() |
| SWP702 | All models with air bag | Bonnet pull handle |
![]() |
| SWP707 | All models without air bag | Bonnet cable |
![]() |
| SWP708 | All models with air bag | Bonnet cable |
![]() |
| SWP112 | All models | Brake calliper guide kit. [Eliminates brake shudder] |
![]() |
| SWP47 | 1.8d | Diesel stop solenoid For Delphi / Lucas equipment |
|
| SWP5899 | 1.0, 1.1, 1.3, 1.3 CAT, 1.4, 1.4 CAT, 1.6, 1.6 Turbo, 1.6 XR2i, 1.8d | Cross member support engine cradle mounting LH |
![]() |
| EM1542 | 1.1, 1.3, 1.4, 1.6, 1.6 Turbo, 1.6 XR2i | Engine mounting, lower |
![]() |
| SWP1111 | 1.4, 1.6 CVH | Air filter breather tube |
![]() |
| FSRL | All models | Side repeater lens, AMBER |
![]() |
| SWP24 | All models | Side repeater lens, bulb holder |
![]() |
| SWP6225 | All models | Washer pump, single outlet |
![]() |
| SWP6689 | All models | Wiring harness to suit SWP6225 washer pump |
![]() |
| FWP2 | All models | Washer pump, twin outlet |
![]() |
| SWP6689 | All models | Wiring harness to suit FWP2 washer pump |
![]() |
| HN19 | All models | Rear hub nut RH |
![]() |
| SWP2381 | With PAS | Front axial rod or Tie rod, inner L&R |
|
| DC48 | 1800 CVH engine | Oil filler cap |
![]() |
| SWP2183 | 1.8 Diesel | Oil filler cap |
![]() |
| SWP1114 | OHV engine | Thermostat housing |
![]() |
| SWP507 | All models | Emission control valve filter |
![]() |
| SWP61 | All models | Front indicator bulb holder L&R |
![]() |
| SWP79 | 1.6efi, CVH 89 to 96 |
Flame trap / breather |
![]() |
| SWP5958 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump, In-line An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
|
| SWP6345 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump. One straight end, one 90º end An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
|
| SWP6346 | Various Diesel models. Please choose what best suits your vehicle between In-line, One straight end, one 90º end, Both ends at 90º angle | Diesel hand primer pump. Both ends at 90º angle. An arrow shows direction of fuel flow. Pump has a non return valve at one end. Both ends are to suit 8mm fuel pipe |
![]() |
| SWP5880 | 1.0, 1.1, 1.3, 1.3 CAT, 1.4, 1.4 CAT, 1.6, 1.6 Turbo, 1.6 XR2i, 1.8d | Front top strut mounting |
![]() |
| SWP222 | 1.0, 1.1, 1.3, 1.3 CAT, 1.4, 1.4 CAT, 1.6, 1.6 Turbo, 1.6 XR2i, 1.8d | Front top strut mounting bearing |
![]() |
| SWP6726 | 1.1, 1.3, 1.4, 1.6, 1.6i, 1.6 Turbo, 1.6XR2i, 1.6 16v, 1.8D | Driveshaft seal | ![]() |
| SWP6748 | Various models: Please check against photograph |
Under body heat shield [exhaust to floor] & noise insulations on bulk head [30mm OD] |
![]() |